JunaidWap: HOW TO BUILD YOUR OWN 3D STEREO CAMERA

If you ever thought about taking 3D photos or video you are going to love this tutorial. It is based around the oldishRicoh GX8, but you can adapt it to any camera you desire, as long as you can trigger them remotely. The general idea is quite simple, and here is the outline for it:

Take a two digital cameras which can be triggered remotely. Make a frame for the cameras with two compartments, so they are parallel to each other. Make/buy a Y splitter so you can trigger both left and right camera simultaneously. Put the left and right image together using StereoPhoto Maker. Make your own stereo viewer and enjoy your own 3d images.

THE DIMENSIONS OF THE FRAME

For the outer dimensions I used my own hands and two Ricoh GX8 and a CA-1 remote control.
The frame is 260 mm wide and almost 175 mm height.
The spacing between the camera lenses is around 85 mm, and this is the distance you would have to use no matter which camera couple you are using.

BUILDING INSTRUCTIONS FOR THE FRAME

The dimensions of the upper and lower parts A are 12 x 27 x 260 mm.
The dimensions of the four standing parts B are 18 x 27 x 150 mm.
The inner dimensions are: aa = 28 mm, bb= 68 mm and cc = 92 mm.
In the two inner standing parts B need a hole for the two ¼ inch camera screws.
The height for the two camera screws (“tripod plates”) ab = 80 mm

Now here are some more tidbits to explain the photo to diagram relations

The outer-left frame (part B) also have some room for the camera release CA-1.
To hold everything together I used eight furniture bolts barrel nuts M6 x 45mm.
To actually enjoy holding the wooden frame you’ll have to round the edges. For this I used a router.
The mini USB port is on the side of the camera and it’s close to the lower part A. Room has to be made for the two mini USB connectors of the Y-splitter.

FURTHER IMPROVEMENTS TO THE FRAME CAN BE MADE (THOUGH THEY ARE NOT IN MY BUILD)

A level can be added for getting horizontal horizons.
Four rubber feet can be added to protect the cameras when the frame is lying on a table.
Two angle hooks can be added for easy alignment of the cameras after changing the batteries or the left and right SD-cards.
Adding a third ¼ inch camera screw at the bottom of the frame the camera can be fitted on a tripod.
Adding a camera strap for carrying on the shoulder

THE BUILDING INSTRUCTIONS FOR THE Y-SPLITTER

The building of the Y-splitter is trivial:

Cut the two cables in two.
The cable length on the two mini-USB connectors should be around 10 cm.
The cable length on the female USB-connector can be around 5 cm.
Remove the inner parts of the female Din loudspeaker connector.
Drill a hole in the female loudspeaker connector part where the two mini-USB cables fit through.
The female USB-cable fits through the other side of the connector.
Assemble the Y-splitter by connecting the wires with the same colour together and isolating them with tape. The two parts of the female loudspeaker connector can now be put together again.

ASSEMBLING

By adding the cameras, the frame, the remote release, the Y-splitter and the female mini-UB Male USB – connector together you should get your stereo camera.

It should look something like this.

CREATING THE STEREO IMAGES

With this camera you get left and right images. In order not to get confused you better mark the SD-cards with L (left) and R (right). You can use StereoPhoto Maker to create the type of 3D-image you want. I’m rather lazy so I just put them together as a 10 x 15 cm print.